One. Power on : Check all parts of the filter press and associated water before starting. Whether the electricity and gas are normal , the air compressor can be started normally.
　　
(1) . According to the elastic level of the filter belt, adjust the air pressure to 0.25 0.35Mpa to start the main engine.
　　
(2) . Open the sludge pump by running the filter belt at a certain rate.
　　
⑶. The pool was concentrated sludge sludge (sludge flow type determination) at a constant flow pump into the mixing bucket dosing, dosing pump is turned on while the quantitative dosing (flow agent integrated debugging and experimentally determined). Adjust the flow rate of the sludge and the flow of the medicament by adjusting the ball valve . Start the reaction stirring motor deceleration and dehydration stirring cage motor reducer.
â‘·. Dewatered and filtered off with spray ball cage, starting spray pump, with high-pressure water main pressure mud during the spray cleaning, dehydration and lower filter belt filter, filter press in order to ensure the smooth sludge dewatering is Shutdown : The filter press is working.
　　
II. Shutdown and cleaning machine.
â‘´. Stop into the mud sludge and dosing pumps and dosing pumps shut down.
(2) . Run the filter belt at a certain rate.
(3) . After draining the remaining sludge in the mixing drum to the filter belt, the sludge on the filter belt is completely filtered.
(4) . It is necessary to thoroughly clean the filter belt and the dehydration mixing cage . Open each spray ball valve , start the spray pump , make the filter belt filter run a few times without any load , spray the filter belt and the dewatering cage filter . Pay attention to the spray. When cleaning the dewatering cage , the dehydration and agitation motor reducer should be turned on , so that the dewatering cage can be thoroughly cleaned during the rotation process after the filter belt and the dewatering cage are cleaned.
(5) . Turn off the spray pump , and the main unit and the dehydration cage motor turn off the air compressor.
⑹. Stop the air supply. If the filter does not work for a long time, should be drained of gas pressure within the system, a pneumatic system to extend the life of high pressure hose and finally with artificial irrigation water receiving tray each other slime and mud residues At
⑺. Ensure the machine clean and tidy, pay attention when washing, do not get water on the motor and electrical box.
　　
The Litehome 120° LED Linear Light uses SANAN 2835 lamp beads, which have high luminous efficiency, narrow spectrum, good monochromaticity, high color rendering, eco-friendly, no lead, mercury and other toxic substances, precise constant current, low light decline. This Linear Light can reach L80B10, that is, 80% of the lamps can maintain 90% of the original luminous flux after 5 years of use. The light uses Boke driving power, and its power conversion efficiency reaches 90%, which greatly reduces energy consumption and saves energy. All our lights will undergo an 8-hour aging test before leaving the factory to ensure that the lamps customers receive are good performance and non-damaged lamps. 5-year warranty. During the warranty period, the malfunctioning lamp can be replaced free of charge.
Commercial Lighting,Kitchen Island Lighting Pendant,Kitchen Led Light,Shop Lighting
SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com