Brick real stone paint
Firstly design the brick size according to the requirements, then use the wooden frame on the wall surface with the primer to make the brick shape, spray it, and remove the wooden frame before the real stone paint has not dried.
Vertical surface spraying
Using the circle-cutting method, the distance is 30cm-40cm, and the radius is about 15cm horizontally, and the spray gun is used up and down. The spray speed is fast and uniform, and it is easy to control. If one row and one row of main overlapping spray is used, the speed is slow. The upper and lower intersections are difficult to control evenly, which will affect the appearance and cause paint defects.
Roman cylindrical spraying
Because it is cylindrical, it is sprayed with "M" line. The distance is about 40cm. The spray gun should be sprayed on the vertical cylinder. From top to bottom, spray one side and then turn to the other side. The steering angle is about 60 degrees.
Square column spraying
The square column has sharp edges and corners, and it is easy to blur the edges due to uneven spraying. For the convenience of spraying, the edges and corners are sprayed at a distance of about 50cm, and the spray is applied at a long distance. The fog is scattered and the area is large and uniform. If the distance is too close, slightly Attention will be sprayed thick, uneven spray, so that the angular lines will not appear, losing the overall aesthetic appearance of the original building.
Cylindrical small gourd spraying
Modern buildings use cylindrical small gourds as railings, most of which require real stone paint. Because of their small size, they are very decorative, and the spraying process is more detailed. The hoist column decorated with railings is too close. In some places, it is impossible to spray on the front side. Therefore, it is impossible to achieve the desired effect according to the general conventional spraying method. Spraying with a small nozzle, a distance of about 40cm, fast spray real stone paint, spray from the top to the bottom side, can not be sprayed on the front side, use the method of shaking the gun to make the real stone paint around it, then brush it with a brush Real stone paint, if you don't spray it, you can use a brush to slightly apply a layer; then spray it with a spray gun, not too thin, not too thick, cover the brush marks, thin can not play very good The protective effect is thicker, which covers the original line beauty, and may also cause undesirable surface phenomena such as cracks.
Resin bond is a kind of organic bond, the grinding wheel made of this bond has high strength, has certain elasticity, low heat resistance, good self-sharpening, easy production and short process cycle. It can manufacture Grinding Wheels with working speed higher than 50 m/s and very thin grinding wheels. Its application range is second only to ceramic binder, widely used in rough grinding, waste grinding, cutting and free grinding, such as grinding steel ingot, casting burr etc.. Can manufacture high speed, high finish grinding wheel, heavy load, cutting and various special requirements of grinding wheel.
In tool grinding, the cutting tool materials with high hardness, thermal hardness, wear resistance and enough strength and toughness, such as carbon tool steel, alloy tool steel, high speed steel, hard alloy, etc., are grinded with resin strong grinding wheel to achieve ideal accuracy. The surface roughness and correct geometry make the cutting edge have high sharpness and durability
Saw Blade,Brazing Diamond Saw Blade,Diamond Key Chain Saw Blade,Abrasive Paper Grinding Sheet
Henan Jinlun Superhard Material Co., Ltd , https://www.jinlunsuperhard.com