The biggest precaution when handing over the house is - a priori check! Whether you are a rough house or a hardcover room, stick to the principle of "receiving the house after the house." As for the need to find an inspector to inspect the house? In one sentence, you answer "no gold diamonds do not take porcelain," the insider looks at the doorway, the layman only has a look at the excitement. Do not save hundreds of blocks, and then put the online home inspection strategy once again, and then signed the check-in order, do not look for the inspector, and later pay for their own money is not the price, let alone other problems. So today, I will study with Xiaobian to find the steps required for the home inspector to inspect the house!
What steps and content are included in the inspection of the inspector?
1. Enter the door. Check that the closure is tight and that the surface of the door is scratched or scratched.
2, the power box. Check if the border is loose and the switch is normal.
3. Multimedia box. Check if there is sufficient wiring, whether to reserve the power supply board and whether there is a bracket frame (the router is installed later).
4. Check the wall. Check that the proportion of the mortar on the wall is up to standard and that there is no empty drum. (The proportion of mortar is not up to standard: the popular saying is that when the wall is treated, the cement has less sand. The consequence is that the wall can't be painted when it is renovated, and it must be reprocessed before it can enter the decoration.
5. Check the ground. The ground is usually empty and cracked.
6. Check the power supply. Check if the electric box is short-circuited, tripped, etc., and if the fire line is reversed.
7. Check the windows. Check for tight closure and support for rust.
8. Is the yin and yang angle vertical? There is a range of rectification: it is an error of 3 mm.
9, the measurement layer is high. Through the layer height, there will be great guidance for the next step of renovation. The net height is not 2.8 meters, suggesting that there is less ceiling, otherwise the space is very depressed, and usually the height of the different rooms is different, and the living room is lower than the bedroom.
10. Measure the flatness of the wall surface by the ruler
11. Check the kitchen. Check for the phenomenon of water seepage. If the waterproofing is not done, it will appear because the water seepage causes the alkali return of the wall surface.
12, check the bathroom
A. If the height of the shower is normal, it is usually 100-115CM after tiling. The water level is 15CM.
B. The sinking type of toilet is installed in a squat, the depth is usually 30CM. It is recommended to buy 22-23CM squats in addition to the sewer and submersible bay (to avoid spending money or eventually causing the sputum to be exposed outside and causing safety hazards) Not sinking toilets usually only install toilets, which requires a certain amount of hole spacing. Usually the hole spacing is 30CM or 28CM or even 40CM. With these data, there is reference data when selling the toilet (pitch distance refers to The middle point of the wall to the lower row is reduced by 3CM, and 3CM is the thickness of the tile.)
The above is the detailed answer to the small editor about the inspector. After reading it, I still look for the inspector to inspect the house. I don’t know if you are satisfied with the introduction of the decoration home network. If you want to know more about the inspector. The wonderful content, please also continue to pay attention to our decoration encyclopedia section!
More related wonderful reading:
How to find the home inspection division to find out what the precautions are
8pcs T handle hex key set,hex key set,hex key manufacturer,T handle hex key
henan horn tools co.,ltd. , https://www.horntoolsltd.com