Observe the hydropower cabling before drilling a hole. The first step is to drill a hole in the skirting line. Before drilling, you must observe the location of the hydropower wiring. Because in the home renovation, the hydropower engineering pipeline is buried in many walls. The location of the pipe is just below the switch socket, so it is a good position to punch and avoid damage. 
When drilling holes, it is necessary to pay attention to the distance between the holes. Professional tools should be used to drill holes. The interval between drill holes should not be too large, and the interval between the interfaces should be smaller, otherwise the baseboards will be difficult to stick to the walls. For example, if the length of the baseboard is 2m, then the spacing should be about 40cm when drilling. Then the small wooden bar is nailed into the hole that has just been hit, and the nail fixing the skirting line is nailed to the wooden bar and is directly nailed to the wall. The nail is easy to loosen. 
3. Clean the wall before fixing. Before fixing the skirting board, clean the wall so that the skirting board will fit completely against the wall and there will be no unsightly gaps. Look for the position of the drill hole, fix the nail on the baseboard, and use a special threaded nail to fix the nail on the baseboard. This will make the effect stronger. In addition, when fixing the baseboard, it is necessary to pay attention to whether it is close to the wall, and the nail should be completely immersed in the baseboard. The surface should not be seen. 
Fourth, we must do a good job in corners and splicing processing Baseboard is originally intended to cover the expansion joints of the floor, so that the ground is more beautiful, so we must do a good job corner treatment. The baseboards of the corners are usually spliced ​​and installed after being cut at a 45-degree angle so as not to leave unsightly marks on the interface; the edge of the baseboard intersects with a plane to scrape and make it flat. The baseboard completely clings to the wall, leaving no gaps. Here, special attention must be paid to the flatness of the corners; in addition to the polymer, density board, and baseboard of the wood material, there will be characteristics of thermal expansion and contraction. Therefore, the baseboard on the corner should also be the same as the floor, leaving about 1cm expansion joints. This four-point attention to good measure, there is absolutely no problem installing the skirting, so when the decoration to this step, please be sure to pay attention to the next oh. Baseboard installation
StrongLED GC Control System signal source, GC Master PC is the central brain of the whole GC control system. The design concept of product refinement is integrated into the industrial application environment, aiming to provide not only the products with reliable technical performance, but also beautiful and exquisite products to the customers.
StrongLED GC control system signal source, GC Master PC is the central brain of the whole GC control system.
The design concept of product refinement is integrated into the industrial application environment, aiming to provide not only the products with reliable technical performance, but also beautiful and exquisite products to the customers.
The product is equipped with StrongPlayer software authorization.
The system compatibility is verified by the project to ensure the safe and stable operation of related software.
Data security is guaranteed.
There are basic model, standard model, and flagship model for customers to choose.It passes internal reliability test to ensure safe and stable operation of products under industrial environment.
Led Master Controller,Dmx512 Master Controller,Smart Dmx 512 Controller ,SPI Digital Master Controller
StrongLED Lighting Systems (Suzhou) Co., Ltd. , https://www.strongledcn.com