The bathroom is the part that each household can't avoid in the process of home decoration, and the waterproof performance is undoubtedly an important criterion to determine the quality of the bathroom decoration. How can we achieve good waterproof performance? The following will be learned together with the Xiaobian. A professional bathroom waterproof construction method.
1. Prepare materials
Buy professional waterproofing products for toilets , auxiliary materials such as cement, and special tools such as brushes.
2, construction steps
a, brush the first time waterproof paint.
Before brushing, it is best to clean the bathroom a bit, and the overall environment is dry, clean and tidy. It is a key factor affecting the waterproof effect of the bathroom . When brushing, the brushing height is the same. Referring to the thickness standard of the product track, all corners of the bathroom are inspected and checked for omissions. Check whether the grass roots are firm and there are no cracking, bubbling or peeling problems.
b, brush the second time waterproof paint.
After completing the previous step, do not rush to proceed with the next step. Let it dry for a while before the paint dries out.
Once again, clean the bathroom once, carefully clean the floating dust on the surface, repair the place where the cement agglomerates and loosens the base layer, and rehabilitate some empty locations, such as pipe roots, drainage holes, yin and yang angles, and the problems left over from hydropower renovation on the wall. In this small series, we remind everyone that the yin and yang corners should be rounded and the best use of cement mortar should be used to pave the ground before the second step of toilet waterproof construction. In order to achieve the result that the paint is not thick enough or not uniform enough to weaken the waterproof effect.
c, shop protection layer.
The protective layer is also an indispensable part of the bathroom waterproofing , so that subsequent operations can be prevented from damaging the waterproof layer. The protective layer should completely cover the waterproof layer. It must not be left out and it should be closely attached to the base layer. Due to the large amount of water used in the toilets, all kinds of pipelines are also very dense. Therefore, once a place is not covered, it may cause the overall waterproof construction to fail. Therefore, it is necessary to be cautious in some corner areas to ensure that the workers are laying protective layers. All coverage is in place.
d, closed water test.
The closed water test is the last step to verify the success of the construction of the bathroom waterproofing . When operating, the water level at the ground point should be at least two centimeters higher and maintain the effect for 24 hours. If no penetration occurs during this time, it means that the water proof is very good. Success, otherwise it means failure, need to be repaired again.
Xiao Bian concludes: Well, the above is a professional construction method and steps that everyone is very concerned about the bathroom waterproof , and I hope that everyone in the specific practice carefully and carefully treat every detail, to ensure that the waterproof is correct and effective, to avoid due to improper operation future trouble.
Our Tungsten Carbide Tipped Cutters(TCT hole saws) are a superior alternative to conventional Bi-Metal Hole saws. They cut faster, cleaner, and last longer. Say goodbye to burnt out, smoking holesaws. Try a T.C.T. you'll love it.
Tungsten cutters cut through, steel plate, iron, aluminium, copper, cast iron, and most importantly, stainless steel and other tough alloys.
The spring loaded pilot bit ejects the cut slug, saving time. The cutter body then cuts a clean, burr-free hole faster than conventional twist drills or hole saws.
T.C.T. cutters are the standard for electrical construction, transit work and general metal fabrication. The spring on the pilot bit ejects the cut slug.
With normal care, Tool life is significantly longer than other hole cutting tools. Inexpensive resharpening will allow repeated use
Tct Hole Saw,Tct Cutting Disc,Carbide Circular Saw Blade,Tct Hole Saw Cutter
Behappy Crafts (suzhou)Co.,Ltd , https://www.craftsbehappy.com